forums.smartfoxserver.com

Hi Lapo,

Thanks for your feedback.
I test the application with above given instruction. I check the KillConnection(), retry and resume feature in the application, it was working fine.
To test those feature, I created an extension which send me private and public message respectively after an interval of 6 seconds. And in client side after receiving private or public message I call KillConnection() after 15 sec.
Application receive public and private messages after 6 sec and KillConnection() also work. I also test the application by unplugging the LAN wire to test hrc+ and I receive the messages but if I unplugged the cable for long time then I receive the "Connection Retry!!!" message and sample application freeze and I don't receive any further messages from SmartFox and also not any message of disconnection or connection lost.
Can you help us in this kind of situation.

Thanks

Didn't I mention that unplugging the ethernet cable won't work?

Hi Lapo,

Sorry, I guess I was not able to express myself properly.
Actually I want to check the response of the smartfoxserver if we loose the internet connection for longer time, then how the application behave and how the messages will send to the client application.
In order to check the above scenario, If we use the killConnection() method then it retry and resume the connection at instant so I am not able to test the scenario where we loose the connection for long period of time.

Thanks

Then shut down your internet connection instead of pulling the network plug. If you are running a modem or router shut it off and back on at a later time.

Hi Lapo,

Merry Xmas !!!!
Recently I faced a problem in connection like I establish the connection with smartfox and handle all event like retry, resume and lost connection.
Suddenly someone by-mistake restarted the server so because of that I got "Connection Retry" message but not able to get any further message from the SFS, that's why I am not able to show the user completely disconnected from the server as I am assuming connection can be resumed or lost because it is in connection retry phase.
Can we handle this kind of scenario in the application and how?

Thanks

Merry xmas to you too

No, if you turn off/restart the server no User will be able to reconnect because the entire state of the server is lost.
People will have to connect from scratch.

In any case the client should signal the DISCONNECT event, as far as I can remember. Just make sure you are using at least version 2.7 of the server.

Hello Lapo,

I am using the latest SFS 2.7x at my end but didn't receive the DISCONNECTION message if server restart.
I always get the RETRY message on server restart but no disconnection message that's why cleanup operation on DISCONNECTION at client side will not performed.

Thanks